Siemens 6FX5002-2DC10-1BF0: Pre-Assembled DRIVE-CLiQ Signal Cable

This is a ready-to-use cable for Siemens drives. It connects SINAMICS S120 motor modules to the control system. The cable is 10 meters long and has robust IP20/IP67 connectors. It includes 24V power for the connection.

Complete Product Details

Order Number: 6FX5002-2DC10-1BF0 (also 6FX50022DC101BF0)

Product Family: MOTION-CONNECT 500

Cable Type: DRIVE-CLiQ Signal Cable, Pre-assembled

Primary Use: For SINAMICS S120 Motor Modules with SINUMERIK 840D sl

Cable Length: 10 meters

Connector Ratings: IP20 on one end (control cabinet), IP67 on the motor end.

Special Feature: Includes conductors for 24 Volt DC supply.

Electrical Standards: Designed for high-speed digital signal transmission.

Shielding: Fully shielded for noise immunity in industrial environments.

Bending Radius: Minimum 5x cable diameter for safe installation.

Operating Temperature: -5°C to +70°C (Flexing), -25°C to +80°C (Fixed)

Net Weight: Approximately 1.25 kg (2.76 lb)

Packaging: Supplied as 1 piece per package.

Compliance: Meets RoHS environmental directives.

Country of Origin: Slovakia

Commodity Code: 85444290

Frequently Asked Questions

Q: Can I use this cable to connect a motor to a SINAMICS G120 drive?

A: No. This specific 6FX5002 cable is designed for the DRIVE-CLiQ interface used on SINAMICS S120 motor modules and SINUMERIK 840D sl systems. The G120 series typically uses different connectors.

Q: What is the advantage of the IP67 connector?

A> The IP67 rating means the connector is dust-tight and can withstand temporary immersion in water. This allows it to be used directly on the motor housing in harsh, wet factory environments without an extra enclosure.

Q: Is the 24V power supplied by the cable itself?

A: No. The cable contains wires to carry the 24V DC power from the control unit (like the CU320) to the connected device (like a motor module or sensor). You must provide a 24V power source at the system end.

Q: Can I cut and re-terminate this cable if it's too long?

A: It is not recommended. The cable is sold as a pre-assembled, tested unit. Cutting and fitting new connectors may compromise the shielding, signal integrity, and IP rating. It is best to order the exact length needed.

Q: My old DRIVE-CLiQ cable failed. Is this a direct replacement?

A> Yes, if your old cable has the same part number (6FX5002-2DC10-1BF0) or is a 10m pre-assembled DRIVE-CLiQ cable, this is a direct replacement. Always verify the connector types match your equipment.

Package Includes

1 x Siemens DRIVE-CLiQ Signal Cable, 10 meters, part number 6FX5002-2DC10-1BF0.

Shipping & Warranty

Fast Delivery: Shipped worldwide via FedEx, UPS, or DHL.

Quality Promise: This product comes with a 12-month warranty against defects.

© 2025 Ubest Automation Limited. All rights reserved.
Original Source: https://www.ubestplc.com/
Contact: sales@ubestplc.com | Phone: +86 180 3000 5825