Bently Nevada 9200 – rugged two-wire velocity transducer

Ordering options and complete suffix information

Below you find the full tree structure for model 9200-06-01-10-00. Each segment defines a critical feature of the two-wire transducer.

• Model 9200 – Two-wire velocity seismoprobe transducer
  • 06 — Mounting angle / min. operating frequency: 0° ±100°, 10 Hz (600 cpm)
  • 01 — Connector option: top mount (no cable)
  • 10 — Mounting base: circular, M10×1 stud
  • 00 — Agency approval: no approvals required

Core specifications – sensitivity and electrical data

• Brand: Bently Nevada · Model: 9200-06-01-10-00 (two-wire velocity)
• Sensitivity: 20 mV/mm/s (500 mV/in/s) ±5% (at proper termination and calibration angle)
• Calibration load: 10 kΩ across terminals A-B, output taken from pins A and B
• Temperature coefficient: 0.2 % / °C
• Coil resistance: 1.25 kΩ ±5% • Locked coil inductance: 125 mH typical
• Dynamic range (displacement): 2.54 mm (0.100 in) peak-to-peak maximum
• Velocity range: 25 mm/s (1 in/s) at +22 °C casing vibration, 100 Hz, 10 kΩ load

Environmental and mechanical toughness

• Operating / storage temperature (9200): -29°C to +121°C (-20°F to +250°F)
• Relative humidity: Up to 95% non-condensing; fully non-submerged when ordered with integral cable
• Case material: Anodized aluminium A204 • Gasket: Neoprene
• Height: 102 mm (4 in) typ. (depends on connector) • Diameter: 41 mm (1.6 in) typ.
• Weight (9200): ≈ 300 grams (10.5 ounces)

Frequently asked questions (FAQ)

• What is the exact sensitivity of the Bently Nevada 9200? 20 mV/mm/s ±5% when correctly terminated and oriented at calibration angle.
• Can I use this two-wire sensor in high-temperature areas? Yes, the 9200 works from -29°C up to +121°C, suitable for most industrial applications.
• Does the transducer include a cable? No, option 01 means top mount without cable – you can connect your own shielded twisted pair.
• What mounting thread does the base provide? The unit comes with an integrated M10×1 stud (option 10).
• Which output terminals should I use? Take the signal across pins A and B; the load must be 10 kΩ for calibrated sensitivity.

© 2026 Ubest Automation Limited. https://www.ubestplc.com/ All rights reserved.
Contact: sales@ubestplc.com Phone: +86 180 3000 5825